Dell Force10 S4820T FTOS Command Reference Guide - Page 90
linecard 4-port 40G line card, EX04PH
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
www.dell.com | support.dell.com Example (C-Series) FTOS#show linecard 3 -- Line card 11 -- Status : not present FTOS#linecard 3 ? E46TB 36-port GE 10/100/1000Base-T with RJ45 - 8-port FE/GE with SFP - 2-port 10GE with SFP+ E46VB 36-port GE 10/100/1000Base-T with RJ45 and PoE - 8-port FE/GE with SFP - 2-port 10GE with SFP+ E48PB 48-port FE/GE line card with SFP optics (CB) E48TB 48-port GE 10/100/1000Base-T line card with RJ45 interfaces (CB) E48VB 48-port GE 10/100/1000Base-T line card with RJ45 interfaces and PoE (CB) EX4PB 4-port 10GE LAN PHY line card with XFP optics (CB) EX8PB 8-port 10GE LAN PHY line card with XFP optics (CB) FTOS#linecard 3 EX4PB FTOS#show linecard 3 -- Line card 11 -- Status : not present Required Type : EX4PB - 4-port 10GE LAN PHY line card with XFP optics (CB) Note: It is advisable to shut down interfaces on a line card that you are hot-swapping. Related Commands show linecard Display the line card(s) status. linecard (4-port 40G line card) ex Pre-configure an empty slot in an E-Series ExaScale switch for a 4-port 40 GigabitEthernet line card or reconfigure a slot in which you have hot-swapped a 4-port 40G line card. Syntax linecard slot-number card-type {linerate | oversubscribed} active-ports port-set0 port-number [port-number] port-set1 port-number [port-number] Parameters slot-number card-type linerate oversubscribed active-ports Enter the slot number in which you will use the line card. Range: 0 - 13 on an E1200i; 0 - 5 on an E600i. Enter the line card ID. Valid values are: EX04PH: Configures the slot for a 6-port 40GE line card with 10M CAM (LC-EH-40GE-4P). EX04PJ: Configures the slot for a 6-port 40GE line card with 40M CAM (LC-EJ-40GE-4P). Configure two ports on the line card to transmit data at full line rate (40 Gbps). Configure four ports on the line card for oversubscribed data transmission. Enable the active ports for the specified mode (linerate or oversubscribed). 90 | Control and Monitoring