Dell Force10 S4820T FTOS Command Reference Guide - Page 244

www.dell.com | support.dell.com Example FTOS(conf)#mac access-list access-list standard TestMAC FTOS(config-std-macl)#? deny Specify packets to reject description List description exit Exit from access-list configuration mode no Negate a command or set its defaults permit Specify packets to forward remark Specify access-list entry remark seq Sequence numbers show Show Standard ACL configuration permit c e s Syntax Parameters Defaults Command Modes Command History Configure a filter to forward packets from a specific source MAC address. permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {any | mac-source-address mac-source-address-mask} command. any mac-source-address mac-source-address-mask count byte log monitor Enter the keyword any to forward all packets received with a MAC address. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to log the packets. (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, refer to the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Not configured. CONFIGURATION-MAC ACCESS LIST-STANDARD Version 8.1.1.0 Version 7.6.1.0 Introduced on E-Series ExaScale Support added for S-Series 244 | Access Control Lists (ACL)