Dell Force10 S4820T FTOS Command Reference Guide - Page 1170
ipv6 pim rp-candidate, ipv6 pim sparse-mode
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1170 highlights
www.dell.com | support.dell.com ipv6 pim rp-candidate e Specify an interface as an RP candidate. Syntax Parameters Defaults Command Modes Command History ipv6 pim rp-candidate interface [priority-value] interface priority-value Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter a number as the priority of this RP Candidate, which is included in the Candidate-RP-Advertisements. Range: 0 (highest) to 255 (lowest) No default values or behavior CONFIGURATION Version 8.3.19.0 Version 8.3.12.0 Version 7.4.1.0 Introduced on S4820T Introduced on the S4810. Introduced ipv6 pim sparse-mode e Enable IPv6 PIM sparse mode on the interface. Syntax Defaults Command Modes Command History ipv6 pim sparse-mode To disable IPv6 PIM sparse mode, enter no ipv6 pim sparse-mode. Disabled INTERFACE Version 8.3.19.0 Introduced on S4820T 1170 | PIM-Sparse Mode (PIM-SM)