Dell Force10 S4820T FTOS Command Reference Guide - Page 880
redistribute, show ip bgp ipv6 unicast
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 880 highlights
www.dell.com | support.dell.com redistribute c e Redistribute routes into BGP. Syntax Parameters Defaults Command Modes Command History Usage Information Related Commands redistribute [connected | static] [route-map map-name] To disable redistribution, use the no redistribution [connected | static] [route-map map-name] command. connected static route-map map-name Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series TeraScale If you do not configure default-metric command, in addition to the redistribute command, or there is no route map to set the metric, the metric for redistributed static and connected is "0". To redistribute the default route (0::0/0) configure the neighbor default-originate command. neighbor default-originate Inject the default route. show ip bgp ipv6 unicast c e View the current MBGP routing table for the E-Series. Syntax show ip bgp ipv6 unicast [network [network-mask] [length]] 880 | IPv6 Border Gateway Protocol (IPv6 BGP)