Dell Force10 S4820T FTOS Command Reference Guide - Page 766
match ipv6 address, match ipv6 next-hop
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 766 highlights
www.dell.com | support.dell.com • match ipv6 route-source • route-map • set ipv6 next-hop • show config • show route-map match ipv6 address c e s Configure a filter to match routes based on IPv6 addresses specified in an access list. Syntax match ipv6 address prefix-list-name To delete a match, use the no match ipv6 address prefix-list-name command. Parameters prefix-list-name Enter the name of IPv6 prefix list, up to 140 characters. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S-Series Introduced support on the E-Series ExaScale Introduced support on the C-Series Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced support on the E-Series TeraScale Related Commands match ipv6 next-hop match ipv6 route-source Redistribute routes that match the next-hop IP address. Redistribute routes that match routes advertised by other routers. match ipv6 next-hop c e s Configure a filter which matches based on the next-hop IPv6 addresses specified in the IPv6 prefix list. Syntax match ipv6 next-hop prefix-list prefix-list-name To delete a match, use the no match ipv6 next-hop prefix-list prefix-list-name command. Parameters prefix-list prefix-list-name Enter the keywords prefix-list followed by the name of configured prefix list, up to 140 characters. Defaults Not configured. 766 | IPv6 Access Control Lists (IPv6 ACLs)