Dell Force10 S4820T FTOS Command Reference Guide - Page 1415
snmp-server contact
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1415 highlights
Example • v1v2cwriteu/ v1v2cwriteg - maps to a community with rw (read-write) permissions This command is indexed by the community-name parameter. If the snmp-server community command is not configured, you cannot query SNMP data. Only Standard IPv4 ACL and IPv6 ACL is supported in the optional access-list-name. The command options ipv6, security-name, and access-list-name are recursive. In other words, each option can, in turn, accept any of the three options as a sub-option, and each of those sub-options can accept any of the three sub-options as a sub-option, and so forth. The following example demonstrates the creation of a standard IPv4 ACL called "snmp-ro-acl" and then assigning it to the SNMP community "guest": FTOS(conf)# ip access-list standard snmp-ro-acl FTOS(config-std-nacl)#seq 5 permit host 10.10.10.224 FTOS(config-std-nacl)#seq 10 deny any count ! FTOS(conf)#snmp-server community guest ro snmp-ro-acl FTOS(conf)# Related Commands Note: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP; TCP, ICMP rules are not valid for SNMP. In IPv6 ACLs port rules are not valid for SNMP. ip access-list standard ipv6 access-list show running-config snmp Name (or select) a standard access list to filter based on IP address. Configure an access list based on IPv6 addresses or protocols. Display the current SNMP configuration and defaults. snmp-server contact c e s z Configure contact information for troubleshooting this SNMP node. Syntax snmp-server contact text To delete the SNMP server contact information, use the no snmp-server contact command. Parameters text Enter an alphanumeric text string, up to 55 characters long. Defaults No default values or behavior Command Modes CONFIGURATION Simple Network Management Protocol and Syslog | 1415