Dell Force10 S4820T FTOS Command Reference Guide - Page 1424

www.dell.com | support.dell.com Parameter Defaults Command Modes Command History Usage Information Related Commands interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. The IP address assigned to the management interface is the default. CONFIGURATION Version 8.3.19.0 Introduced on S4820T Version 8.3.11.1 Introduced on Z9000 Version 8.3.12.0 Added description of keyword vlan Version 8.3.7.0 Introduced on S4810 Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale. Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command For this snmp-server trap-source command to be enabled, you must configure an IP address on the interface and enable the interface configured as an SNMP trap source. snmp-server community Set the community string. snmp-server user c e s z Configure a new user to an SNMP group. Syntax snmp-server user name {group_name remote ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv des56 priv password] [access access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name] To remove a user from the SNMP group, use the no snmp-server user name {group_name remote ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv des56 priv password] [access access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name] command. 1424 | Simple Network Management Protocol and Syslog