Dell Force10 S4820T FTOS Command Reference Guide - Page 406

www.dell.com | support.dell.com neighbor maximum-prefix c et s Control the number of network prefixes received. Syntax neighbor ip-address | peer-group-name maximum-prefix maximum [threshold] [warning-only] To return to the default values, use the no neighbor ip-address | peer-group-name maximum-prefix maximum command. Parameters ip-address peer-group-name maximum threshold warning-only (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group. Enter a number as the maximum number of prefixes allowed for this BGP router. Range: 1 to 4294967295. (OPTIONAL) Enter a number to be used as a percentage of the maximum value. When the number of prefixes reaches this percentage of the maximum value, FTOS sends a message. Range: 1 to 100 percent. Default: 75 (OPTIONAL) Enter the keyword warning-only to set the router to send a log message when the maximum value is reached. If this parameter is not set, the router stops peering when the maximum number of prefixes is reached. Defaults threshold = 75 Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor next-hop-self c et s Enables you to configure the router as the next hop for a BGP neighbor. Syntax neighbor ip-address | peer-group-name next-hop-self To return to the default setting, use the no neighbor ip-address | peer-group-name next-hop-self command. Parameters ip-address peer-group-name (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group. 406 | Border Gateway Protocol IPv4 (BGPv4)