Dell Force10 S4820T FTOS Command Reference Guide - Page 1060

www.dell.com | support.dell.com clear ipv6 mroute e Clear learned multicast routes on the multicast forwarding table. To clear the PIM tib, use clear ip pim tib command. Syntax clear ipv6 mroute {group-address [source-address] | *} Parameters group-address [source-address] * Enter multicast group address and source address (if desired) to clear information on a specific group. Enter the addresses in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zero. Enter * to clear all multicast routes. Defaults No default behavior or values Command Modes EXEC Privilege Command History Related Commands Version 7.4.1.0 show ipv6 pim tib Introduced Display the IPv6 PIM Tree Information Base. debug ipv6 mld_host Enable the collection of debug information for MLD host transactions. Syntax [no] debug ipv6 mld_host [int-count | interface type] [slot/port-range] Parameters Use the no debug ipv6 mld_host command to discontinue collection of debug information for the MLD host transactions. int-count interface type Enter the keyword count to indicate the number of required debug messages. Enter the following keywords and slot/port information: • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For a 10G Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a 40G interface, enter the keyword fortyGigE followed by the slot/port information. • For a management interface enter the keyword managementinterface followed by the slot/port information. • For a port-channel interface, enter the keyword port-channel followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by the slot/port information. Default Command Modes Disabled EXEC 1060 | Multicast