Dell Force10 S4820T FTOS Command Reference Guide - Page 665

port-channel failover-group c e s Access the PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group. Syntax port-channel failover-group To remove all LAG failover groups, use the no port-channel failover-group command. Defaults No default values or behavior Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Introduced for C-Series, E-Series, and S-Series Usage Information This feature groups two LAGs to work in tandem as a supergroup, so that, for example, if one LAG goes down, the other LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to configure failover groups. For details, refer to the Port Channel chapter in the FTOS Configuration Guide. Related Commands group Group two LAGs in a supergroup ("fate-sharing group"). show interfaces port-channel Display information on configured Port Channel groups. show config c e s Display the current configuration of the selected LAG. Syntax Command Modes show config INTERFACE PORTCHANNEL Example Command History FTOS(conf-if-po-1)#show config ! interface Port-channel 1 no ip address shutdown FTOS(conf-if-po-1)# Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Interfaces | 665