Dell Force10 S4820T FTOS Command Reference Guide - Page 928

www.dell.com | support.dell.com If you are configuring only one area in your network, you do not need to run both Level 1 and Level 2 routing algorithms. The IS type can be configured as Level 1. log-adjacency-changes e Generate a log messages for adjacency state changes. Syntax log-adjacency-changes To disable this function, enter no log-adjacency-changes. Defaults Adjacency changes are not logged. Command Modes ROUTER ISIS Command History Version 8.3.19.0 Version 8.3.12.0 Introduced on S4820T Introduced on S4810 Usage This command enables you to monitor adjacency state changes, which is useful when you monitor Information large networks. Messages are logged in the system error message facility. lsp-gen-interval e Set the minimum interval between successive generations of link-state packets (LSPs). Syntax lsp-gen-interval [level-l | level-2] interval seconds [initial_wait_interval seconds [second_wait_interval seconds]] To restore default values, use the no lsp-gen-interval [level-l | level-2] interval seconds [initial_wait_interval seconds [second_wait_interval seconds]] command. Parameters level-l level-2 interval seconds (OPTIONAL) Enter the keyword level-1 to apply the configuration to generation of Level-1 LSPs. (OPTIONAL) Enter the keyword level-2 to apply the configuration to generation of Level-2 LSPs. Enter the maximum number of seconds between LSP generations. Range: 0 to 120 seconds Default: 5 seconds 928 | Intermediate System to Intermediate System (IS-IS)