Dell Force10 S4820T FTOS Command Reference Guide - Page 408

www.dell.com | support.dell.com Parameters Defaults Command Modes Usage Information Command History ip-address peer-group-name map-name in out (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group. Enter the name of an established route map. If the Route map is not configured, the default is deny (to drop all routes). Enter the keyword in to filter inbound routes. Enter the keyword out to filter outbound routes. Not configured. ROUTER BGP Address Family (conf-router_bgp_af) When you apply a route map to outbound routes, only routes that match at least one section of the route map are permitted. If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound policies on that peer. Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor route-reflector-client c et s Configure a neighbor as a member of a route reflector cluster. Syntax neighbor ip-address | peer-group-name route-reflector-client To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use the no neighbor ip-address | peer-group-name route-reflector-client command. Parameters ip-address peer-group-name (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group. All routers in the peer group receive routes from a route reflector. Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) 408 | Border Gateway Protocol IPv4 (BGPv4)