Dell Force10 S4820T FTOS Command Reference Guide - Page 1007

Related Commands protocol lldp (Configuration) debug lldp interface show lldp neighbors show running-config lldp Enable LLDP globally. Debug LLDP Display the LLDP neighbors Display the LLDP running configuration hello c e s Configure the rate at which the LLDP control packets are sent to its peer. Syntax Parameters Defaults Command Modes Command History hello seconds To revert to the default, use the no hello seconds command. seconds Enter the rate, in seconds, at which the control packets are sent to its peer. Rate: 5 to 180 seconds Default: 30 seconds 30 seconds CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Version 8.3.19.0. Version 8.3.7.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series mode c e s Set LLDP to receive or transmit. Syntax mode {tx | rx} To return to the default, use the no mode {tx | rx} command. Parameters tx rx Enter the keyword tx to set the mode to transmit. Enter the keyword rx to set the mode to receive. Link Layer Discovery Protocol (LLDP) | 1007