Dell Force10 S4820T FTOS Command Reference Guide - Page 1510
member, show interface dei-honor
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1510 highlights
www.dell.com | support.dell.com Related Commands dei enable member c e s Syntax Parameters Defaults Command Mode Command History Usage Information Related Commands Assign a Stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in its configuration. member interface To remove an interface from a Stackable VLAN, use the no member interface command. interface Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1 to 128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabyte Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Not configured. CONF-IF-VLAN Version 8.2.1.0 Introduced on the E-Series ExaScale Version 7.6.1.0 Support added for C-Series and S-Series E-Series original Command You must enable the Stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to adding a member to the VLAN. vlan-stack compatible Enable Stackable VLAN on a VLAN. show interface dei-honor c s Display the dei honor configuration. Syntax show interface dei-honor [interface slot/port | linecard number port-set number] 1510 | VLAN Stacking