Dell Force10 S4820T FTOS Command Reference Guide - Page 63

Example Example (S4810 & S4820T) FTOS#upgrade system ? ftp: Copy from remote file system (ftp://userid:password@hostip/filepath) (flash partition A:/ B:) scp: Copy from remote file system (scp://userid:password@hostip/filepath)(flash partition (A:/ B:) tftp: Copy from remote file system (tftp://hostip/filepath)(Flash Ppartition A:/b:) FTOS#$pgrade system ftp://username:[email protected]/FTOS-SB-7.7.1.0.bin (Flash partition A:/ B Erasing Sseries ImageUpgrade Table of Contents, please wait .!...! 12946259 bytes successfully copied FTOS#reload upgrade fpga-image e This command only be used on systems with SFM3 modules (and only when required by the upgrade procedure in the release notes). Upgrade the FPGA version in the specified E-Series SFM3 and automatically initiate an automatic reset to complete the version upgrade. Syntax upgrade fpga-image {sfm} {all | id} [booted | flash:// | ftp: |slot0: | tftp] Parameters sfm rpm all id Enter the keyword sfm to upgrade the FPGA on the SFMs. Enter the keyword rpm to upgrade all processors on the RPM. Enter the keyword all to upgrade the FPGA on all the SFMs. Enter the keyword id to upgrade the FPGA on all a specific SFM. Enter the path to the upgrade source. Entering updates the FPGA from the flash. Defaults No default values or behavior Command Modes EXEC Privilege Command History Version 8.3.1.0 Version 7.5.1.0 Added rpm option Introduced on E-Series Example FTOS#upgrade sfm 1 autoreset SFM1: upgrade in progress SFM1: upgrade complete SFM1 is active. Resetting it might temporarily impact traffic. Proceed with reset [confirm yes/no]: yes FTOS# File Management | 63