Dell Force10 S4820T FTOS Command Reference Guide - Page 33
config file which is not present in the specified location, then the, startup-configuration is loaded.
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Usage Information To display these changes in the show bootvar command output, you must save the running configuration to the startup configuration (copy running-config startup-config or write)...... Dell Force10 strongly recommends using local files for configuration (RPM0 or RPM1 flash or slot0). When you specify a file as the boot config file, it is listed in the boot variables (bootvar) as LOCAL CONFIG FILE. If you do not specify a boot config file, then the startup-configuration is used, although the bootvar shows LOCAL CONFIG FILE = variable does not exist. When you specify a boot config file, the switch reloads with that config file, rather than the startup-config. Note that if you specify a local config file which is not present in the specified location, then the startup-configuration is loaded. The write memory command always saves the running-configuration to the file labeled startup-configuration. When using a LOCAL CONFIG FILE other than the startup-config, use the copy command to save any running-configuration changes to that local file. The following text is an example of output for show bootvar with no boot configuration: FTOS#show bootvar PRIMARY IMAGE FILE = flash://FTOS-EF-8.2.1.0.bin SECONDARY IMAGE FILE = flash://FTOS-EF-7.6.1.0.bin DEFAULT IMAGE FILE = flash://FTOS-EF-7.5.1.0.bin LOCAL CONFIG FILE = variable does not exist PRIMARY HOST CONFIG FILE = variable does not exist SECONDARY HOST CONFIG FILE = variable does not exist PRIMARY NETWORK CONFIG FILE = variable does not exist SECONDARY NETWORK CONFIG FILE = variable does not exist CURRENT IMAGE FILE = flash://FTOS-EF-8.2.1.0.bin CURRENT CONFIG FILE 1 = flash://startup-config CURRENT CONFIG FILE 2 = variable does not exist CONFIG LOAD PREFERENCE = local first BOOT INTERFACE GATEWAY IP ADDRESS = variable does not exist The following text is an example of output for show bootvar with a boot configuration: FTOS#show bootvar PRIMARY IMAGE FILE = flash://FTOS-EF-8.2.1.0.bin SECONDARY IMAGE FILE = flash://FTOS-EF-7.6.1.0.bin DEFAULT IMAGE FILE = flash://FTOS-EF-7.5.1.0.bin LOCAL CONFIG FILE = variable does not exist PRIMARY HOST CONFIG FILE = variable does not exist SECONDARY HOST CONFIG FILE = variable does not exist PRIMARY NETWORK CONFIG FILE = variable does not exist SECONDARY NETWORK CONFIG FILE = variable does not exist CURRENT IMAGE FILE = flash://FTOS-EF-8.2.1.0.bin CURRENT CONFIG FILE 1 = flash://CustomerA.cfg CURRENT CONFIG FILE 2 = variable does not exist CONFIG LOAD PREFERENCE = local first BOOT INTERFACE GATEWAY IP ADDRESS = variable does not exist File Management | 33