Dell Force10 S4820T FTOS Command Reference Guide - Page 876

www.dell.com | support.dell.com Parameters Defaults Command Modes Command History To return to the default values, use the no neighbor ipv6-address | peer-group-name maximum-prefix maximum command. ipv6-address peer-group-name maximum threshold warning-only (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group. Enter a number as the maximum number of prefixes allowed for this BGP router. Range: 1 to 4294967295. (OPTIONAL) Enter a number to be used as a percentage of the maximum value. When the number of prefixes reaches this percentage of the maximum value, the E-Series software sends a message. Range: 1 to 100 percent. Default: 75 (OPTIONAL) Enter the keyword warning-only to set the router to send a log message when the maximum value is reached. If this parameter is not set, the router stops peering when the maximum number of prefixes is reached. threshold = 75 ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series TeraScale neighbor next-hop-self c e Allows you to configure the router as the next hop for a BGP neighbor. Syntax Parameters Defaults Command Modes neighbor ipv6-address | peer-group-name next-hop-self To return to the default setting, use the no neighbor ipv6-address | peer-group-name next-hop-self command. ipv6-address peer-group-name (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group. Disabled. ROUTER BGPV6-ADDRESS FAMILY 876 | IPv6 Border Gateway Protocol (IPv6 BGP)