Dell Force10 S4820T FTOS Command Reference Guide - Page 259

• set next-hop • set origin • set tag • set weight • show config • show route-map continue c e s Configure a route-map to go to a route-map entry with a higher sequence number. Syntax continue [sequence-number] Parameters sequence-number (OPTIONAL) Enter the route map sequence number. Range: 1 - 65535 Default: no sequence number Defaults Not Configured Command Modes ROUTE-MAP Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced Usage Information The continue feature allows movement from one route-map entry to a specific route-map entry (the sequence number). If the sequence number is not specified, the continue feature simply moves to the next sequence number (also known as an implied continue). If a match clause exists, the continue feature executes only after a successful match occurs. If there are no successful matches, continue is ignored. Match clause with Continue clause The continue feature can exist without a match clause. A continue clause without a match clause executes and jumps to the specified route-map entry. With a match clause and a continue clause, the match clause executes first and the continue clause next in a specified route map entry. The continue clause launches only after a successful match. The behavior is: • A successful match with a continue clause, the route map executes the set clauses and then goes to the specified route map entry upon execution of the continue clause. • If the next route map entry contains a continue clause, the route map will execute the continue clause if a successful match occurs. Access Control Lists (ACL) | 259