Dell Force10 S4820T FTOS Command Reference Guide - Page 983

Command History Usage Information Related Commands Version 8.3.19.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S4820T. Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1). The Default VLAN contains only untagged interfaces. interface vlan Configure a VLAN. default-vlan disable c e s Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly configured as a member of another VLAN. Defaults Command Modes Command History Usage Information The default VLAN is enabled. CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.3.1.0 Introduced on S4820T. Introduced no S4810 Introduced no default vlan disable is not listed in the running-configuration, but when the default VLAN is disabled, default-vlan disable is listed in the running-configuration. enable vlan-counters ex Display VLAN counters for ingress and/or egress hardware. You must be in restricted mode to use this command. Syntax enable vlan-output-counters [ingress | egress | all] To return to the default (disabled), use the no enable vlan-output-counters command. Defaults Disabled - VLAN counters are disabled in hardware (all linecards/port-pipes) by default. Command Modes CONFIGURATION Layer 2 | 983