Dell Force10 S4820T FTOS Command Reference Guide - Page 1186

www.dell.com | support.dell.com Command Modes Command History Usage Information Related Commands INTERFACE VLAN Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Introduced on S4820T Introduced on S4810 Introduced on C-Series and S-Series The VLAN: • Can be in only one mode, either community, isolated, or primary. • Mode can be set to community or isolated even before associating it to a primary VLAN. This secondary VLAN will continue to work normally as a normal VLAN even though it is not associated to a primary VLAN. (A syslog message indicates this.) • Must not have a port in it when the VLAN mode is being set. Only ports (and port channels) configured as promiscuous, host, or PVLAN trunk ports (as described above) can be added to the PVLAN. No other regular ports can be added to the PVLAN. After using this command to configure a VLAN as a primary VLAN, use the private-vlan mapping secondary-vlan command to map secondary VLANs to this VLAN. private-vlan mapping secondary-vlan show interfaces private-vlan show vlan private-vlan show vlan private-vlan mapping switchport mode private-vlan Set the mode of the selected VLAN to primary and then associate secondary VLANs to it. Display type and status of PVLAN interfaces. Display PVLANs and/or interfaces that are part of a PVLAN. Display primary-secondary VLAN mapping. Set the PVLAN mode of the selected port. private-vlan mapping secondary-vlan c s Map secondary VLANs to the selected primary VLAN. Syntax Parameters [no] private-vlan mapping secondary-vlan vlan-list To remove specific secondary VLANs from the configuration, use the no private-vlan mapping secondary-vlan vlan-list command syntax. vlan-list Enter the list of secondary VLANs to associate with the selected primary VLAN, as described above. The list can be in comma-delimited or hyphenated-range format, following the convention for range input. 1186 | Private VLAN (PVLAN)