Dell Force10 S4820T FTOS Command Reference Guide - Page 783

Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.4.2.1 Introduced on the S4820 Introduced on the S4810 Introduced the S-Series Usage Information On the S4810 and S4820T, First-Hop information is not shown for installed routes in the IPv6 Content Addressable Memory (CAM). However, the same is shown in the Forwarding Information Base (FIB). Note: If a route has a mask greater than 64, no output will be displayed, no output will be displayed for "show ipv6 cam stack-unit unit-number port-set {0-1} ipv6-address" but an equivalent /64 entry would be listed in the "show ipv6 cam stack-unit unit-number port-set {0-1}" output. Similarly, if there is more than one ECMP object with a destination route that has a mask greater than 64, if the first 64 bits in the destination routes of the ECMP objects are the same, only one route is installed in CAM even though multiple ECMP path entries exist. Note: On the S4810 and S4820T, the self address will be displayed in the neighbor portion for the "show ipv6 cam stack-unit unit-number port-set" command. show ipv6 control-plane icmp Displays the status of the icmp control-plane setting for the Error Rate limit setting. Syntax Default show ipv6 control-plane icmp 100 Command Mode EXEC Command History Version 8.3.19.0 Introduced on the S4820T. Version 8.3.12.0 Introduced on the S4810. Related Commands ipv6 flowlabel-zero Configure IPv6 address auto-configuration for the management interface. show ipv6 fib linecard c e View all Forwarding Information Base entries. Syntax Parameters show ipv6 fib linecard slot-number {summary | ipv6-address} slot-number Enter the number of the line card slot. E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a E300 IPv6 Basics | 783