Dell Force10 S4820T FTOS Command Reference Guide - Page 262
match ip address
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 262 highlights
www.dell.com | support.dell.com Parameters interface Enter the following keywords and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/ port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For the loopback interface, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094, 1-2094 for ExaScale (can used IDs 1-4094). Defaults Not configured Command Modes ROUTE-MAP Command History Version 8.5.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Added support for 4-port 40G line cards on ExaScale. Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series Related Commands match ip address match ip next-hop match ip route-source match metric match route-type match tag Redistribute routes that match an IP address. Redistribute routes that match the next-hop IP address. Redistribute routes that match routes advertised by other routers. Redistribute routes that match a specific metric. Redistribute routes that match a route type. Redistribute routes that match a specific tag. match ip address c e s Configure a filter to match routes based on IP addresses specified in an access list. Syntax match ip address prefix-list-name Parameters prefix-list-name Enter the name of configured prefix list, up to 140 characters. Defaults Not configured. 262 | Access Control Lists (ACL)