Dell Force10 S4820T FTOS Command Reference Guide - Page 998

www.dell.com | support.dell.com Parameters interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/ port information. Command Modes EXEC EXEC Privilege Example FTOS#sh fefd FEFD is globally 'ON', interval is 10 seconds, mode is 'Aggressive'. INTERFACE Gi 5/0 Gi 5/1 Gi 5/2 Gi 5/3 Gi 5/4 Gi 5/5 Gi 5/6 Gi 5/7 Gi 5/8 Gi 5/9 Gi 5/10 Gi 5/11 FTOS# MODE Aggressive Aggressive Aggressive Aggressive Aggressive Aggressive Aggressive Aggressive Aggressive Aggressive NA Aggressive INTERVAL (second) 10 10 10 10 10 10 10 10 10 10 NA 10 Table 31-5. Description of show fefd display STATE Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Locally disabled Err-disabled Field Interface Mode Interval State Description Displays the interfaces type and number. Displays the mode (aggressive or normal) or NA if the interface contains fefd reset in its configuration. Displays the interval between FEFD packets. Displays the state of the interface and can be one of the following: • bi-directional (interface is up and connected and ing neighbor's echoes) • err-disabled (only found when the FEFD mode is aggressive and when the interface has not n its neighbor's echoes for 3 times the message interval. To reset an interface in this state, use the fefd reset command.) • unknown (only found when FEFD mode is normal • locally disabled (interface contains the fefd reset command in its configuration) • Admin Shutdown (interface is disabled with the shutdown command) Related Commands fefd fefd disable Enable Far-End Failure Detection. Disable FEFD on an interface only. 998 | Layer 2