Dell Force10 S4820T FTOS Command Reference Guide - Page 407

Defaults Command Modes Usage Information Command History Disabled. ROUTER BGP Address Family (conf-router_bgp_af) If the set next-hop command in the ROUTE-MAP mode is configured, its configuration takes precedence over the neighbor next-hop-self command. Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor remove-private-as c et s Remove private AS numbers from the AS-PATH of outgoing updates. Syntax neighbor ip-address | peer-group-name remove-private-as To return to the default, use the no neighbor ip-address | peer-group-name remove-private-as command. Parameters ip-address peer-group-name (OPTIONAL) Enter the IP address of the neighbor to remove the private AS numbers. (OPTIONAL) Enter the name of the peer group to remove the private AS numbers Defaults Disabled (that is, private AS number are not removed). Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor route-map c et s Apply an established route map to either incoming or outbound routes of a BGP neighbor or c peer group. Syntax neighbor [ip-address | peer-group-name] route-map map-name [in | out] To remove the route map, use the no neighbor [ip-address | peer-group-name] route-map map-name [in | out] command. Border Gateway Protocol IPv4 (BGPv4) | 407