Dell Force10 S4820T FTOS Command Reference Guide - Page 749

Command Modes Command History Usage Information Related Commands CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S4820T Introduced support on the S4810 Introduced on the S-Series Introduced on the E-Series ExaScale Introduced on the C-Series Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced on the E-Series TeraScale The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation for detailed specification on entries allowed per ACL. show config View the current configuration. ipv6 control-plane egress-filter c e s Enable egress Layer 3 ACL lookup for IPv6 CPU traffic. Syntax ipv6 control-plane egress-filter Defaults Not enabled Command Modes EXEC Privilege Command History Version 8.3.19.0 Introduced on the S4820T Version 8.3.10.0 Introduced support on the S4810 permit c e s Syntax Select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP to configure a filter that match the filter criteria. permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command. IPv6 Access Control Lists (IPv6 ACLs) | 749