Dell Force10 S4820T FTOS Command Reference Guide - Page 996

www.dell.com | support.dell.com fefd interval e Set an interval between control packets. Syntax fefd interval seconds To return to the default value, enter no fefd interval. Parameters seconds Enter a number as the time between FEFD control packets. Range: 3 to 300 seconds Default: 15 seconds Defaults 15 seconds Command Modes INTERFACE Related Commands Command History fefd Enable Far-End Failure Detection. Version 8.3.19.0 Version 8.3.12.0 Introduced on S4820T. Introduced on S4810. Legacy E-Series command fefd mode e Change the FEFD mode on an interface. Syntax fefd mode {normal | aggressive}] To return the FEFD mode to the default of normal, enter no fefd mode. Parameters normal aggressive (OPTIONAL) Enter the keyword normal to change the link state to "unknown" when a far-end failure is detected by the software on that interface. When the interface is placed in "unknown" state, the software brings down the line protocol. (OPTIONAL) Enter the keyword aggressive to change the link state to "error-disabled" when a far-end failure is detected by the software on that interface. When an interface is placed in "error-disabled" state, you must enter the fefd reset command to reset the interface state. Defaults normal Command Modes INTERFACE Related Commands fefd Enable Far-End Failure Detection. 996 | Layer 2