Dell Force10 S4820T FTOS Command Reference Guide - Page 619
ipg Gigabit Ethernet interfaces, Virtual LAN, VLAN Commands, Access Control Lists ACL
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 619 highlights
Parameters vlan-id Enter a number as the VLAN Identifier. Range: 1 to 4094. Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1. Command Modes CONFIGURATION Command History Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced for E-Series Example Usage Information FTOS(conf)#int vlan 3 FTOS(conf-if-vl-3)# For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN) Commands. FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in VLANs. IP ACLs are supported. Refer to the Access Control Lists (ACL) chapter. Related Commands interface interface loopback interface null interface port-channel show vlan shutdown tagged untagged Configure a physical interface. Configure a loopback interface. Configure a null interface. Configure a port channel group. Display the current VLAN configuration on the switch. Disable/Enable the VLAN. Add a Layer 2 interface to a VLAN as a tagged interface. Add a Layer 2 interface to a VLAN as an untagged interface. ipg (Gigabit Ethernet interfaces) e Set the Inter-packet gap (IPG) to 8 bytes for traffic on a Gigabit Ethernet interface. Syntax ipg 8 To return to the default setting, enter no ipg. Parameters 8 Enter the keyword 8 to set the IPG to 8 bytes. Defaults 12 bytes Interfaces | 619