Dell Force10 S4820T FTOS Command Reference Guide - Page 1449

Parameters Defaults Command Modes Command History Related Commands 0-7 Enter the stack member unit identifier, from 0 to 7, of the switch on which you want to set the management priority. 1-14 This preference parameter allows you to specify the management priority of one backup switch over another, with 0 the lowest priority and 14 the highest. The switch with the highest priority value will be chosen to become the management unit if the active management unit fails or on the next reload. 0 CONFIGURATION Version 7.7.1.0 Introduced on S-Series reload show system (S-Series, S4810 and S4820T) Reboot FTOS. Display the current status of all stack members or a specific member. stack-unit provision s Pre-configure a logical stacking ID of a switch that will join the stack. This is an optional command that is executed on the management unit. Syntax stack-unit 0-11 provision {S25N|S25P|S25V|S50N|S50V|S4810|S4820T} Parameters 0-11 S25N|S25P|S25V| S50N|S50V|S4810 |S4820T Enter a stack member identifier, from 0 to 11, of the switch that you want to add to the stack. Enter the S-Series model identifier of the switch to be added as a stack member. This identifier is also referred to as the provision type. Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member identifier. Command Modes CONFIGURATION Command History Version 8.3.19.0 Introduced on S4820T Version 7.7.1.0 Introduced on S-Series Related Commands reload show system (S-Series, S4810 and S4820T) Reboot FTOS. Display the current status of all stack members or a specific member. S-Series Stacking Commands | 1449