Dell Force10 S4820T FTOS Command Reference Guide - Page 1289

Syntax Parameters Defaults Command Modes Command History Usage Information timers basic update invalid holddown flush To return to the default settings, enter no timers basic. update invalid holddown flush Enter the number of seconds to specify the rate at which RIP routing updates are sent. Range: zero (0) to 4294967295. Default: 30 seconds. Enter the number of seconds to specify the time interval before routing updates are declared invalid or expired. The invalid value should be at least three times the update timer value. Range: zero (0) to 4294967295. Default: 180 seconds. Enter the number of seconds to specify a time interval during which the route is marked as unreachable but still sending RIP packets. The holddown value should be at least three times the update timer value. Range: zero (0) to 4294967295. Default: 180 seconds. Enter the number of seconds to specify the time interval during which the route is advertised as unreachable. When this interval expires, the route is flushed from the routing table. The flush value should be greater than the update value. Range: zero (0) to 4294967295. Default is 240 seconds. update = 30 seconds; invalid = 180 seconds; holddown = 180 seconds; flush = 240 seconds. ROUTER RIP Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series If the timers on one router are changed, the timers on all routers in the RIP domain must also be synchronized. version c e s Specify either RIP version 1 or RIP version 2. Syntax version {1 | 2} To return to the default version setting, enter no version. Routing Information Protocol (RIP) | 1289