Dell Force10 S4820T FTOS Command Reference Guide - Page 267

Related Commands Version 7.5.1.0 Support added for C-Series pre-Version 6.1.1.0 Introduced for E-Series match interface match ip address match ip next-hop match ip route-source match metric match route-type Redistribute routes that match the next-hop interface. Redistribute routes that match an IP address. Redistribute routes that match the next-hop IP address. Redistribute routes that match routes advertised by other routers. Redistribute routes that match a specific metric. Redistribute routes that match a route type. route-map c e s Enable a route map statement and configure its action and sequence number. This command also places you in the ROUTE-MAP mode. Syntax Parameters Defaults Command Modes Command History route-map map-name [permit | deny] [sequence-number] map-name permit deny sequence-number Enter a text string of up to 140 characters to name the route map for easy identification. (OPTIONAL) Enter the keyword permit to set the route map default as permit. If no keyword is specified, the default is permit. (OPTIONAL) Enter the keyword deny to set the route map default as deny. (OPTIONAL) Enter a number to identify the route map for editing and sequencing with other route maps. You are prompted for a sequence number if there are multiple instances of the route map. Range: 1 to 65535. Not configured If no keyword (permit or deny) is defined for the route map, the permit action is the default. CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Support added for S-Series Access Control Lists (ACL) | 267