Dell Force10 S4820T FTOS Command Reference Guide - Page 348

www.dell.com | support.dell.com Parameters Defaults Command Modes Usage Information Command History ip-address peer-group-name Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group. Disabled. ROUTER BGP If the set next-hop command in the ROUTE-MAP mode is configured, its configuration takes precedence over the neighbor next-hop-self command. Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series neighbor password c e s Enable Message Digest 5 (MD5) authentication on the TCP connection between two neighbors. Syntax Parameters Defaults Command Modes Usage Information neighbor {ip-address | peer-group-name} password [encryption-type] password To delete a password, use the no neighbor {ip-address | peer-group-name} password command. ip-address peer-group-name encryption-type password Enter the IP address of the router to be included in the peer group. Enter the name of a configured peer group. (OPTIONAL) Enter 7 as the encryption type for the password entered. 7 means that the password is encrypted and hidden. Enter a text string up to 80 characters long. The first character of the password must be a letter. You cannot use spaces in the password. Not configured. ROUTER BGP Configure the same password on both BGP peers or a connection does not occur. When you configure MD5 authentication between two BGP peers, each segment of the TCP connection between them is verified and the MD5 digest is checked on every segment sent on the TCP connection. Configuring a password for a neighbor will cause an existing session to be torn down and a new one established. 348 | Border Gateway Protocol IPv4 (BGPv4)