Dell Force10 S4820T FTOS Command Reference Guide - Page 201

Usage Information Related Commands Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Added support for S-Series Added support for C-Series Introduced When all sequence numbers have been exhausted, this feature permits re-assigning new sequence number to entries of an existing prefix list. Prior to 7.8.1.0, names are up to 16 characters long. resequence access-list Resequence an access-list seq c e s Assign a sequence number to a deny or permit filter in an IP access list while creating the filter. Syntax Parameters seq sequence-number {deny | permit} {source [mask] | any | host ip-address}} [count [byte] | log] [dscp value] [order] [monitor] [fragments] sequence-number deny permit source mask any host ip-address count byte log dscp Enter a number from 0 to 4294967290. S4810 and S4820T Range: 0 to 65534 Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this criteria. Enter a IP address in dotted decimal format of the network from which the packet was received. (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address or hostname. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. Access Control Lists (ACL) | 201