Dell Force10 S4820T FTOS Command Reference Guide - Page 175

Related Commands dot1x auth-fail-vlan dot1x reauthentication dot1x reauth-max Configure an authentication failure VLAN. Enable periodic re-authentication of the client. Configure the maximum number of times to re-authenticate a port before it becomes unauthorized. dot1x host-mode c e s Enable single-host or multi-host authentication. Syntax Parameters Defaults Command Modes Command History Usage Information dot1x host-mode {single-host | multi-host | multi-auth} single-host multi-host multi-auth Enable single-host authentication. Enable multi-host authentication. Enable multi-supplicant authentication. single-host INTERFACE Version 8.3.19.0 Version 8.3.12.0 Version 8.4.1.0 Version 8.3.2.0 Introduced on the S4820T Introduced on the S4810 The multi-auth option was introduced on the C-Series and S-Series. The single-host and multi-host options were introduced on the C-Series, E-Series, and S-Series • Single-host mode authenticates only one host per authenticator port, and drops all other traffic on the port. • Multi-host mode authenticates the first host to respond to an Identity Request, and then permits all other traffic on the port. • Multi-supplicant mode authenticates every device attempting to connect to the network on through the authenticator port. dot1x mac-auth-bypass c s Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, FTOS attempts to authenticate the host based on its MAC address. Syntax dot1x mac-auth-bypass Defaults Disabled 802.1X | 175