Dell Force10 S4820T FTOS Command Reference Guide - Page 604
dampening
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 604 highlights
www.dell.com | support.dell.com FTOS(conf-if-te-0/26)#cx4-cable-length long % Error: Unsupported command. FTOS(conf-if-te-0/26)# The figure below shows a successful CX4 cable length configuration. Example (CX4 Cable Length Configuration) FTOS#config FTOS(config)#interface tengigabitethernet 0/52 FTOS(conf-if-0/52)#cx4-cable-length long FTOS(conf-if-0/52)#show config ! interface TenGigabitEthernet 0/51 no ip address cx4-cable-length long shutdown FTOS(conf-if-0/52)#exit FTOS(config)# For details on using XFP ports with CX4 cables, your S-Series hardware guide. Related Commands show config Display the configuration of the selected interface. dampening c e s Configure dampening on an interface. Syntax dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-suppress-time]] To disable dampening, use the no dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-suppress-time]] command syntax. Parameters half-life reuse-threshold suppress-threshold max-suppress-time Enter the number of seconds after which the penalty is decreased. The penalty is decreased by half after the half-life period expires. Range: 1 to 30 seconds Default: 5 seconds Enter a number as the reuse threshold, the penalty value below which the interface state is changed to "up". Range: 1 to 20000 Default: 750 Enter a number as the suppress threshold, the penalty value above which the interface state is changed to "error disabled". Range: 1 to 20000 Default: 2500 Enter the maximum number for which a route can be suppressed. The default is four times the half-life value. Range: 1 to 86400 Default: 20 seconds Defaults Disabled Command Modes INTERFACE (conf-if-) 604 | Interfaces