Dell Force10 S4820T FTOS Command Reference Guide - Page 608

www.dell.com | support.dell.com Related Commands speed (for 10/100/1000 interfaces) negotiation auto Set the speed on the Base-T Ethernet interface. Enable or disable auto-negotiation on an interface. ecmp-group Provides a mechanism to monitor traffic distribution on a LAG link bundle. A system log or SNMP trap is generated when the standard deviation of traffic distribution on a member link exceeds a defined threshold. Syntax ecmp-group {ecmp-path} [interface interface] [monitoring enable] To negate a command, use the no command. Parameters ecmp-path interface monitoring Enter the path number for the LAG. Range: 2 to 64 Enter the following keywords and slot/port to add the interface to the LAG. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Enter the keyword monitoring to monitor the LAG. To enable monitoring, follow by entering the keyword enable. Defaults Off Command Modes CONFIGURATION Command History Version 8.3.19.0 Introduced on S4820T Version 8.3.10.0 Introduced on S4810 flowcontrol c e s Control how the system responds to and generates 802.3x pause frames on 1Gig and 10Gig line cards. Syntax flowcontrol rx {off | on} tx {off | on} threshold { } The threshold keyword is supported on C-Series and S-Series only. 608 | Interfaces